The working principle of Agglomerator machine

After the waste material is put into the pot body of the machine, the material is quickly cut into pieces by the shearing action of the high-speed rotating rotary blade and the fixed blade, and the chopped material or piece flows along the wall surface of the pot body under the centrifugal force of the rotary cutter plate At the same time, the material is turned up and down by the action of sizing, and moves from the surrounding to the center of the pot body. Due to the friction between the materials themselves and the friction with the pot wall and the blade at high speed, a large amount of friction heat is generated, so that the temperature of the material rises rapidly to reach In the semi-plasticized state, they stick to each other and form small pieces. Before the material is about to agglomerate, spray all the pre-prepared quantitative water into the material. When the cold water meets the hot material, it will quickly vaporize and take away the surface heat of the material. The surface of the material is cooled rapidly to prevent agglomeration, and then it is crushed into particles (granules with irregular sizes) by the crushing action between the rotating blade and the fixed blade. During the chopping process, appropriate pigments can also be added for coloring as required.